Agency Compliance; Wireless Display Sensor (Wds); Configuration Procedure - Trane BCHE Installation, Operation And Maintenance Manual

Installation - Controls
Table 23. Wireless sensor specifications (continued)
Component
Radio channels
Address range
Minimum time between transmissions
Maximum time between transmissions
(a) Range values are estimated transmission distances for satisfactory operation. Actual distance is job specific and must be determined during site evaluation.

Agency Compliance

The European Union (EU) Declaration of Conformity is
available from your local Trane

Wireless Display Sensor (WDS)

Configuration Procedure

Note: Sensors shipped with the fan coil are pre-configured
for three speeds.
The configuration of the sensor determines which system
features can be accessed and changes can be made by
the tenant (for example, changes to cooling/heating mode,
setpoint, or fan speed. Verify system and associated unit
features before configuring the sensor.
The building owner or operator may choose to limit tenant
access to certain features. This can be done through
configuration. Or, if a sensor is configured to match all
control capabilities of the building automation system, the
locking feature can be used to restrict the tenant from
making changes.
To configure settings on the wireless display sensor
(WDS), follow this procedure in the order presented.
1. Press the configuration button for three seconds.
Figure 77. Configuration button
The display will change to configuration mode. When
the sensor is in configuration mode, a wrench symbol
appears on the display and the menus are separated
by lines, as shown in Figure 78, p.
78
Type
16
000 to 999
30 seconds
15 minutes
®
office.
Configuration
button
78.
Figure 78. Wrench is shown in configuration mode
2. Press the center button on the keypad to begin the
configuration process.
Figure 79.
3. Configure the sensor options in the order shown in the
table.
a. Press right or left arrow to scroll to the next
selection (as illustrated)
b. Press center button or down arrow to o move to the
next menu (as illustrated in
4. Review the display to ensure that you have selected
the correct configuration.
5. To return the display to operating mode, press the
configuration button (see Step 1).
Table 24, p. 79
BCX-SVX002A-EN