Table of Contents
Advertisement
4
1.0
Complete Installation
This section provides detailed procedures for properly
installing, wiring, and configuring the Genesis Multiphase
Detector.
1.1
Unpacking
Unpack the instrument carefully. Ensure that all compo-
nents have been removed from the packing material. Check
all the contents against the packing slip and report any dis-
crepancies to the factory.
Before proceeding with the installation, do the following:
• Inspect all components for damage. Report any damage to
the carrier within 24 hours.
• Make sure the nameplate model number on the probe and
main electronics agree with the packing slip and purchase
order.
• Record the model and serial numbers for future reference
when ordering parts.
For optimal performance (and correlation to the Calibration
Certificate included with all units), confirm the model and
serial numbers shown on the nameplates of the Genesis
probe and main electronics are identical.
NOTE: To avoid moisture ingress in the housing, covers should be fully
tightened at all times. For same reason, conduit entries should
be properly sealed.
1.2
Electrostatic Discharge (ESD)
Handling Procedure
Magnetrol electronic instruments are manufactured to the
highest quality standards. These instruments use electronic
components that may be damaged by static electricity pre-
sent in most work environments.
The following steps are recommended to reduce the risk of
component failure due to electrostatic discharge.
• Ship and store circuit boards in anti-static bags. If an anti-
static bag is not available, wrap the board in aluminum
foil. Do not place boards on foam packing materials.
• Use a grounding wrist strap when installing and removing
circuit boards. A grounded workstation is recommended.
Model Number
Serial Number
63-601 Genesis Models ED1 & ED2 Multiphase Detector
Advertisement
Table of Contents
Troubleshooting
