Device Setup - Identity; Device Setup - Basic Configuration; Device Setup - I/O Configuration - Genesis ED1 Installation And Operating Manual

1.5.5 Device Setup — Identity
Home Screen
Main Menu
Device Setup
Identity
Basic Config
I/O Config
Display Config
Advanced Config
Factory Config
1.5.6 Device Setup — Basic Configuration
Home Screen
Main Menu
Device Setup Identity
Basic Config
I/O Config
Display Config
Advanced Config
Factory Config
1.5.7 Device Setup — I/O Configuration
Home Screen
Main Menu
Device Setup
Identity
Basic Config
I/O Config
Display Config
Advanced Config
Factory Config
63-601 Genesis Models ED1 & ED2 Multiphase Detector
Model
Magnetrol S/N
Long Tag
Probe S/N
Probe Model No.
Device ID
Hardware Rev.
Probe Hardware Rev.
Firmware Rev.
CoP Firmware Rev.
Probe Firmware Rev.
Level Units:
Inches
Feet
Millimeters
Centimeters
Meters
Level Offset
Upper Dielectric
Emulsion Top % Water
Emulsion Btm % Water
Analog Output 1
Primary Variable (AO1)
Analog Output 2
Secondary Variable (AO2)
Analog Output 3
Tertiary Variable (AO3)
Analog Output 4
Quaternary Variable (AO4)
Upper Level
Emulsion Top Level
Water Level
Sand Level
Upper Thickness
Emulsion Thickness
Probe Buildup (Only AO2, AO3, and AO4)
Main Electronics Temp (Only AO2, AO3, and AO4)
Probe Elec Temp (Only AO2, AO3, and AO4)
4 mA Set Pt (LRV)
20 mA Set Pt (URV)
Failure Alarm
High (22 mA)
Low (3.6 mA)
Hold Last Output Value
Damping
15