Table of Contents
Advertisement
7. Use seven M6 x 19 mm or 24 x 3/4-inch screws to attach each of the two vertical mounting brackets
on the chassis to the two vertical mounting rails on the rack (total of 14 screws). See Figure 30 on
page 65.
Figure 30. Attaching the Chassis to the Rack
1. Vertical mounting rails on the rack.
2. Mounting brackets for two post racks
3. Six M6 x 19 mm or 10-24 x 3/4 in. Phillips screws used to attach each side bracket to a front
mounting rail (use a total of 12 screws)
4. Eight M6 x 10 mm screws used to attach each bottom support rail to the chassis (use a total of
16 screws for both rails)
8. Use eight M6 x 10 mm screws to attach the bottom-support rails to the chassis (use a total of 16
screws for both bottom support rails). See Figure 30 on page 65.
9. If you removed any fabric modules before moving the chassis, replace each one in the chassis as
follows:
a) Holding the front of the fabric module (the side with the LEDs), turn the module so that the front
side is vertical.
Note : The top of the module has an alignment bracket running from the rear to the front. The
electrical connectors will be at the bottom.
b) Align the rear of the fabric module to an open fabric slot and insert the bracket on top of the
module into the track at the top of the slot.
Note : If there are only three fabric modules to install, install them in fabric slots 1, 3, and 5, and
be sure that there are blank filler plates installed in the open slots.
c) Slide the module part way into the slot.
d) Press the ejector button on the front of the module, to release the levers from the front of the
module.
e) Rotate the levers away from the front of the module and hold them while sliding the module all the
way into the slot.
f) Simultaneously rotate both levers to the front of the module. They click when locked to the front
of the module.
Chapter 3. Installing the IBM c-type SAN Device 65
Advertisement
Table of Contents
