Moving A Chassis Onto A Rack Or Cabinet - IBM SAN192C-6 Installation, Service And User Manual

onto the rack (see the following figure). Ensure that the chassis does not get caught on any of the
expansion edges of the bottom-support rail.
Figure 29. Moving a Chassis onto a Rack or Cabinet
1. Push the sides of the lower half of the front side of the chassis.
2. Push the chassis into the rack until its mounting bracket touches the vertical mounting rails on
the rack.
Tip : To adjust the placement of the chassis on the bottom-support rails, you can use the handles on
the sides of the chassis.
5. If the mechanical lift is raised above the height of the bottom-support rails, gently lower it to the level
of the rails or no more than 1/4 inch (0.6 cm) below the rails.
This action helps to prevent the bottom of the chassis from getting caught on the bottom expansion
edges of the bottom-support rails.
6. Push the chassis all the way onto the rack so that the vertical mounting brackets on the chassis come
in contact with the vertical mounting rails on the rack.
64 IBM Storage Networking SAN192C-6, SAN384C-6 and SAN768C-6: SAN192C-6, SAN384C-6 and
SAN768C-6 Installation, Service, and User Guide