Table of Contents
Advertisement
4. Fan module exhaust
5. Fan power connector
6. Fan and Crossbar fabric switching module LEDs
7. Ground point
8. PSU exhaust
SAN384C-6 Chassis
The SAN384C-6 is a 10-slot chassis with two supervisor modules and up to 8 I/O modules. The chassis
holds up to six crossbar fabric switching modules, up to 8 AC power supplies, and three fan modules.
Airflow is front-to-back (port-side intake) in the SAN384C-6 chassis.
Note : The base configuration of the SAN384C-6 ships with two supervisor modules, three crossbar
fabric switching modules, and six power supplies.
The slots on the front of the chassis are numbered as follows:
• Line card slots 1 to 4 and 7 to 10 are numbered top to bottom. Each slot can hold one 48 port 32 Gbps
Fibre Channel switching module.
• Slots 5 and 6 are side-by-side and numbered left to right. Each slot is half the width of the chassis and
each slot can hold one supervisor module.
• There are two rows of power supply bays at the bottom of the chassis. The top row has bays 1 to 4,
numbered left to right. The bottom row has bays 5 to 8, numbered left to the right. Each bay can hold
one power supply.
The slots on the rear of the chassis are numbered as follows:
• Fan modules 1 to 3 are numbered left to the right. When the fan modules are installed, they cover the
fabric modules.
• Fabric module slots 21 to 26 are numbered left to the right. Slots 21 and 22 hold fabric modules 1 and
2; slots 23 and 24 hold fabric modules 3 and 4; and slots 25 and 26 hold fabric modules 5 and 6. The
slots for the fabric modules are behind the fan modules.
Figure 3 on page 8 shows the front view of the SAN384C-6 chassis.
Chapter 1. Introducing the IBM c-type SAN Directors 7
Advertisement
Table of Contents
