T1/E1 Port Leds; Ethernet Port Leds; Table 5: System Led On The Front Panel; Table 6: T1/E1 Port Leds - Juniper ACX2000 Hardware Manual

T1/E1 Port LEDs

Ethernet Port LEDs

Copyright © 2015, Juniper Networks, Inc.

Table 5: System LED on the Front Panel

Label Color
Green
SYS
Red
The front panel has sixteen T1/E1 ports, each with one pair of port LEDs.
describes the LEDs in more detail.

Table 6: T1/E1 Port LEDs

Name Location
Link Left
Link Right
(remote
alarms)
The front panel of the ACX2000 router has six Gigabit Ethernet RJ-45 ports, and the
ACX2100 router has eight Gigabit Ethernet RJ-45 ports, each with one pair of port LEDs.
Table 7 on page 13 describes the LEDs in more detail.

Table 7: Ethernet Port LEDs

Name Location
Link Left
RX Right
Chapter 2: ACX2000 and ACX2100 Hardware Components
State Description
Blinking Router is transitioning online.
On steadily Router is functioning normally.
Blinking Router has reported an alarm.
On steadily Router has failed.
Color Description
Green Online with no alarms or failures.
Red Active with a local alarm; router has detected a
failure.
– Not enabled.
Yellow Online with alarms for remote failures.
Color State
Green On
– Off
Green Blinking
– Off
Table 6 on page 13
Description
Link is online.
No link.
The port is receiving data.
The port is not receiving data.
13