Display Brightness - Garmin G600 Pilot's Manual

1) While viewing the Aux mode System Setup page, press the MENU key.
2) Turn the large or small MFD knobs to highlight the desired selection and then
press ENT
.
3.4.1.1

Display Brightness

Display brightness mode may be set to manual or automatic. The automatic
mode will set the display brightness based on the ambient light. The manual
mode allows the setting of display brightness between 0 and 100%.
1) Turn the large MFD knob to reach the AUX page group. Press the small MFD
knob to activate the cursor.
2) The Level will be highlighted. Turn the small MFD knob to select the Display
Brightness Level and then press ENT
Figure 3-59 Aux Mode Display Brightness Level Selection
3) If the Level was changed, Manual will be selected. Press the cursor to save the
settings. If you press ENT the Mode setting will be highlighted.
4) With the Mode value highlighted, turn the small MFD knob to select Auto or
Manual and then press ENT
Figure 3-60 Aux Mode Display Brightness Mode Selection
190-00601-02 Rev. B
Figure 3-58 Aux Mode System Setup Page Menu
.
Garmin G600 Pilot's Guide
.
3-47