Garmin G600 Pilot's Manual page 94

INT/NDB Viewing Range
The INT/NDB viewing range option allows you to select the map range
where below that value Intersection and NDB information will be shown on the
MFD. Map ranges above the selected value will not show Intersection and NDB
information. When Off is selected, the information will not be shown.
Figure 3-47 Navigation Map INT/NDB Viewing Range Selection
1) While viewing the Navigation Map Setup page and the Aviation Group active,
turn the large MFD knob to highlight the "INT/NDB" option.
2) Turn the small MFD knob to change the highlighted value.
3) Press ENT to accept the displayed value. The next option will be highlighted.
4) Press the small MFD knob to cancel selection or to end editing and return to
the Navigation Map page or turn the large MFD knob to the next option.
3-36
Garmin G600 Pilot's Guide 190-00601-02 Rev. B