Display Brightness - Garmin G500 Pilot's Manual

Cover TOC
The default values set by the installer during installation are restored by using
the Page Menu options or soft keys. The "Restore Unit Defaults" menu selection
and the DFLT UNIT soft key restores the default MFD Display and System
Display Units settings. The "Restore Airspeed Defaults" menu selection or DFLT
SPD soft key restores the default PFD Airspeeds settings.
The RA TEST soft key activates the Radar Altimeter test mode. For more
details, refer to section 2.
NOTE: Not all Radar Altimeters have the TEST function.
1. While viewing the Aux mode System Setup page, press the MENU key.
2. Turn the large or small MFD knobs to highlight the desired selection and then
press ENT
.
3.2.1.1

Display Brightness

Display brightness mode may be set to manual or automatic. The automatic
mode will set the display brightness based on the ambient light. The manual
mode allows the setting of display brightness between 0 and 100%.
1. Turn the large MFD knob to reach the AUX page group. Press the small MFD
knob to activate the cursor.
2. The Level will be highlighted. Turn the small MFD knob to select the Display
Brightness Level and then press ENT
Figure 3-38 Aux Mode Display Brightness Level Selection
3. If the Level was changed, Manual will be selected. Press the cursor to save the
settings. If you press ENT the Mode setting will be highlighted.
3-28
Figure 3-37 Aux Mode System Setup Page Menu
Garmin G500/G600 Pilot's Guide
.
190-00601-02 Rev. J