General Information; Product Description - Trane WTS Installation, Operation And Maintenance Manual

General Information

This section provides a description of the sensors, as well as part numbers and dimensions.

Product Description

Trane
k temperature input. The sets include sensor, receiver, wiring harness, and two AA lithium
batteries. No further software or hardware is necessary for site evaluation, installation, or
maintenance. Zone temperature is standard on all models.
Notes:
•
•
Trane wireless sensors include the following models:
Model WDS
This configurable sensor has an LCD display. It provides the same functions as many currently
available Trane wired sensors. Configurable features include:
•
•
•
•
•
•
•
•
•
•
Model WTS
This sensor measures and transmits the zone temperature only.
Model WZS
This sensor set transmits the zone temperature, all zone temperature setpoint functions, temporary
occupancy (timed override), and unoccupied (cancel) information to the receiver. The receiver
electrically reproduces the zone temperature resistance, all zone temperature setpoint function
resistances, and temporary occupancy/unoccupied information as sent by the sensor.
6
®
wireless sensor sets are compatible with any Trane unit controller that uses a standard 10
The information in this manual applies to both factory and field installed versions of
the Trane wireless sensor sets.
A service tool cannot be connected to a Trane wireless sensor.
Temperature units: Fahrenheit (ºF) or Celsius (ºC)
Temperature resolution: 1.0, 0.5, or 0.1 degrees
Ability to display setpoint only (zone temperature does not display)
Single, dual, or no setpoint
System settings: auto, off, cool, heat, emergency heat
Dead band (heat/cool setpoint offset for dual setpoint systems)
Fan settings: high, medium, low, auto, off
Timed override request function
Lockable settings to protect against unauthorized use
Service pin request
BAS-SVX04G-EN