Replacing The Receiver Cover; Applying Power To The Receiver - Trane WTS Installation, Operation And Maintenance Manual

Installation

Replacing the Receiver Cover

To replace the cover:
1. Hook the cover over the top of the back plate. Apply light pressure to the bottom of the cover
2. Install the security screw into the bottom of the cover.

Applying Power to the Receiver

Restore power to the UCM. Observe LED5 on the receiver; it will light and stay constantly On when
24 V power is normal.
16
until it snaps in place.
Security screw
LED5 stays constantly On after
applying power to the receiver
BAS-SVX04G-EN