Requesting Temporary Occupancy; Error Codes; Lock Symbol; Testing Signal Strength - Trane WTS Installation, Operation And Maintenance Manual

Requesting Temporary Occupancy

Select to request
occupancy
Select to cancel
occupancy

Error codes

Main processor error
Disassociated
Address set to 000
Software version conflict
Input voltage too high
Sensor failure
Communication error

Lock Symbol

Indicates that the keypad is
locked

Testing Signal Strength

Indicates
excellent signal
strength

Testing Battery Status

Indicates full
battery power
BAS-SVX04G-EN
• If you need heating or cooling after normal business hours, you can request temporary
occupancy by pressing
on the screen and the unoccupied symbol disappears. After 30 seconds, the
unoccupied symbol will re-appear. The system will remain in occupied mode for a pre-
determined period.
• To cancel temporary occupancy, press
symbol will remain on the screen and the occupied symbol will disappear. After 30
seconds, the occupied symbol will re-appear. (Cancellation can be made at any time
during the temporary occupancy period.)
The lock symbol appears if you try to adjust a setting that cannot be changed.
Indicates
satisfactory
signal
strength
Indicates 25% of
battery life left.
Indicates 50% of
Replace batteries.
battery life left.
Flashing symbol
indicates that
approximately 14 days of
operation remain.
and holding it for 2 seconds. The occupied symbol remains
Replace sensor.
Re-associate sensor with receiver. (See
"Disassociation" p. 39.)
Set address to between 001–999.
Replace sensor.
No RF transmission is permitted with an input battery voltage greater
than 3.9 V.
Replace sensor.
Replace sensor.
Indicates poor
signal strength
Press the Test button to display the battery
status symbols.
Use only UL-listed non-rechargeable 1.5 V
lithium AA batteries (Trane p/n X13770035010
or equivalent).
and hold for 2 seconds. The unoccupied
"Manual Association"
Press the Test button to display the signal
strength symbols.
Operation
and
33