Observing the Receiver for Readiness to Associate
After initial power up, the receiver conducts a channel scan for 20 seconds. During this time, the
receiver selects from 16 available channels the clearest channel on which to operate. LED1, LED2,
and LED3 flash rapidly in succession (round-robin style) while the channel scan is in progress, as
shown in part 1 of the illustration.
Important:
After the channel scan is finished, LED3 begins blinking (one-blink pattern) to show that the receiver
is ready to be associated with a sensor. See part 2 of the illustration.
BAS-SVX04G-EN
Do not attempt association (leave the insulation strip in place) until the channel scan
is finished.
1
0
Sec.
2
20
Installation
LED3
17