Testing Signal Strength And Battery Status - Trane WTS Installation, Operation And Maintenance Manual

Testing Signal Strength and Battery Status

To verify that the association process was successful and that the batteries have adequate charge:
1. Firmly press and release the Test button on the bottom of the sensor (as illustrated below).
2. For models WTS and WZS, view LED1, LED2, and LED3 to determine the signal strength. View
3. Record the results in your commissioning statement.
Note: For more information, see
Model WTS and WZS sensors
LED1
LED2
LED3
LED5
Push firmly,
then release
BAS-SVX04G-EN
LED5 to determine the battery status. (See the illustration for model WTS and WZS sensors.)
Note: The LEDs will turn Off after 5 seconds to conserve battery strength.
For model WDS, determine the signal strength and battery status by viewing the symbols on
the sensor display. (See the illustration for model WDS sensors.)
p. 36.
Test button
"Testing Signal Strength," p. 35
Test button
Installation
and "Testing Battery Status,"
Model WDS sensors
Push firmly,
then release
19