Replacing The Receiver Cover; Applying Power To The Receiver - Trane WDS Installation, Operation And Maintenance Manual

Replacing the Receiver Cover

To replace the cover:
1. Hook the cover over the top of the back plate. Apply light pressure to the bottom of
2. Install the security screw into the bottom of the cover.

Applying Power to the Receiver

Restore power to the UCM. Observe LED5 on the receiver; it will light and stay constantly
On when 24 V power is normal.
BAS-SVX04C-EN • Wireless Sensors
the cover until it snaps in place.
Installation
Security screw
LED5 stays constantly On after
applying power to the receiver
17