Remote Control Unit Mcu-004 - Furuno NAVNET TZ2 TZTL12F Operator's Manual

No. Key
7 CANCEL/MOB
key
8 FUNC key
9 HOME/BRILL
key
* The beep sound can be turned on or off with [Notify when NAVpilot is engaged] in
the menu. See section 2.10.8.
1.2.2

Remote Control Unit MCU-004

1
STBY STBY
HOME
• •
AUTO AUTO
BRILL
3
FUNC
5
CURS
CENTER
•
SCRL
7
8
9
CANCEL
MOB
Short push:
• Closes the menu or dialog box.
• Stops the aural alarm.
• Ends the tool mode (End Route, End Move, etc.).
Long push:
• Enters the MOB mark (at the own ship's position).
• Short push: Does the task assigned to the "two finger tap function"
• Long push: Does the task assigned to the "two finger long tap function"
Short push: Shows the Home screen.
Long push: Opens the [Quick Access] window.
No. Key
1 STBY•AUTO
key
2
4
2 HOME/BRILL
key
6
3 CONTROL
key
4 FUNC key
10
5 CURS•SCRL
key
6 CENTER key
7 Rotary knob
1. SYSTEM INTRODUCTION
Description
Function
Switches the steering mode of the FURUNO
NAVpilot series Autopilot between the Stand-by
and AUTO modes. When switching occurs, a
beep sounds* and a message informs you of
Navpilot mode change.
• Stand-by mode→AUTO mode: "Navpilot
Engaged".
• AUTO mode→Stand-by mode: "Navpilot
Disengaged".
• Short push: Opens the Home screen.
• Long push: Opens the Brilliance/Power win-
dow.
Switches between displays that can be con-
trolled with the MCU-004 when multiple displays
are installed in the same network.
• Short push: Performs the task assigned to
the "two finger tap function"
• Long push: Performs the task assigned to
the "two finger long tap function"
Switches the function of the joystick between
the Cursor and Scroll modes.
• Returns own ship to center of screen (Chart
Plotter/Weather/Radar display).
• Cancels the echo history (Fish finder display).
• Selects an item from the [Slide] menu, [Set-
tings] menu, pop-up menu.
• Zooms in/out.
1-5