Furuno NAVNET TZ2 TZTL12F Operator's Manual page 369

15. OTHER FUNCTIONS
[DATA ACQUISITION] section
Menu Item
[GP330B WAAS Mode]
[WS-200 WAAS Mode]
[Data Source]
[Sensor List]
[NMEA0183 Output]
[NMEA 2000 PGN Output] Select [ON] for the PGNs (Parameter Group Number, CAN bus
[Sky View]
[NMEA 2000 Log] menu
Menu item
[Enable NMEA
2000 Log]
[NMEA2000 Log
Storage Location]
[INTERNAL GPS SETUP] section (TZTL12F/TZTL15F only)
Menu Item
[WAAS Mode]
[SC-30 SETUP] section
Menu item
[WAAS Mode]
[Heading Offset]
[Pitch Offset]
[Roll Offset]
[NETWORK SENSOR SETUP] section
The [NETWORK SENSOR SETUP] section allows you to set up compatible FURUNO
NMEA2000 sensors. Calibrations and offsets applied in this menu are also applied to
the sensor itself.
Tap the sensor to access its menus and settings. For details regarding the menu struc-
ture and set up of each sensor, see the appropriate operator's manual, supplied with
the sensor.
15-8
Description
Select [ON] to use the WAAS mode for the
corresponding GPS antenna.
Select the source for each data to input to the system. If two or more
sources are connected for a data, select one using the pull-down dialog
box. (FURUNO sensors are shown at the upper part of the list.)
Show the information for sensors connected to your equipment. Also,
you can set a "Nickname" for them here.
Select [ON] to output NMEA sentences.
(NMEA2000) message) to output from the CAN bus port.
Show the condition of GPS and GEO (WAAS) satellites
on the [GPS SkyView] display. The bearing and eleva-
tion angle of all GPS and GEO satellites (if applicable) in
view of your receiver appear. For the serviceman.
Note: The [GPS SkyView] display can also be shown by
tapping the GPS icon (shown right) on the home screen.
Description
Enable or disable saving of NMEA2000 data.
Select where to save NMEA2000 data.
Set to [OFF] when using external GPS.
Description
Select [ON] to use the WAAS mode.
Enter the offset value for heading.
Enter the offset value for pitching.
Enter the offset value for rolling.
Options (setting range)
[OFF], [ON]
Options (setting range)
[OFF], [ON]
Description
Options (setting range)
[OFF], [ON]
-180° to +180°
-90° to +90°
-90° to +90°