Furuno NAVNET TZ2 TZTL12F Operator's Manual page 31

1. SYSTEM INTRODUCTION
After the welcome screen is cleared, the [NAVIGATION WARNING] screen appears.
Tap [OK] to confirm the warning, and the [LIMITATIONS ON USE] screen appears.
Tap [OK] to confirm the contents.
* To show or hide the welcome screen, go to the Home screen, tap [Settings]→[Gen-
eral], then turn [Show Welcome Screen at startup] on or off.
The color of the lamp in the power switch changes according to equipment state.
Green: Equipment is powered.
Orange: Equipment is not powered but power is flowing to the equipment.
How to turn the power off
Tap the power switch to show the [Quick Access] window.
Tap [Device] to power off only this unit, or [Network] to power off this unit and all other
NavNet TZtouch2 units in the network. A beep sounds, the message "Shutdown in
progress" appears, then the unit shuts down shortly thereafter)
Note 1: If you cannot turn off the power as shown above, or the screen has frozen,
push and hold the power switch until the screen goes blank, wait two seconds, then
release the switch.
Note 2: Do not turn off the power during the start-up. Wait until the start-up is complet-
ed before you turn off the power.
Note 3: The screen refreshes slower in low ambient temperature.
1-12
WARNING - LIMITATIONS ON USE
This product is intended to be used only as an aid to
navigation.
The built-in background charts of this product contain a
limited version of chart datasets only for general
awareness. And also, this detailed chart No. 20202503 is
from Japan Hydrographic office.
Datum information: WGS-84
By pressing [ENT] key, you confirm that you acknowledge
the above warning and accept the limitations of this
product.
DRS6A_X-CLASS
Device
OK
BBDS1
Touch Screen
Network