Table of Contents
Advertisement
5.11.7
Cross track error lines
The color of the cross track error lines is red for the port side,
green for the starboard side. You can show or hide these lines
and set their distance from own ship as follows.
1. Go to the Home screen, then tap [Settings]→[Routes].
2. Turn [Cross Track Error Lines] on or off. For [ON], go to the
next step. For [OFF], tap the close button on the title bar to
finish.
3. Tap [Cross Track Error Value] to display the software key-
board.
4. Set the distance of the cross track error line from your ship
then tap []. The cross track error alarm sounds (if active)
when your ship veers off course by the amount set here.
5. Tap the close button on the title bar to finish.
5.11.8
Waypoint arrival notification
The waypoint arrival notification feature releases audio and visual notifications when
your ship reaches a go to point. For the arrival timing, see section 5.11.5. The notifi-
cation message "Waypoint Crossing" appears. Activate or deactivate this feature as
follows.
1. Open the home screen, then tap [Settings]→[Routes].
2. Turn [Waypoint Crossing Notification] on or off.
3. Tap the close button on the title bar to finish.
5.11.9
End of route notification
The end of route notification feature releases audio and visual notifications when your
ship reaches the end of a route. For the arrival timing, see section 5.11.5. The notifi-
cation message "End of Route" appears. Activate or deactivate this feature as follows.
1. Open the home screen, then tap [Settings]→[Routes].
2. Turn [End of Route Notification] on or off.
3. Tap the close button on the title bar to finish.
5.11.10 How continue navigation at end of route
When you arrive at the final destination, you can keep the destination and route active.
For example, if you set a destination on a small reef and continue fishing while going
back and forth between the destinations, this function can save you from having to set
the destination many times.
1. Go to the Home screen, then tap [Settings]→[Routes]→[End of Route Operation].
2. Tap [Continue Navigation].
Go to the Home screen, then tap [Settings]→[Routes]→[End of Route Operation].
The route is not canceled when arriving at the final destination, and the set course,
XTE lines, bearing and range are displayed. For how to cancel the route see sec-
tion section 5.11.3. If an autopilot is connected, the ship turns after passing the
final destination and continues to sail around the final destination.
5. ROUTES
Cross track
error lines
(Red: port,
Green: starboard)
5-19
Advertisement
Table of Contents
Troubleshooting
