1-10
C
1: I
HAPTER
NTRODUCING THE
Default Settings for
the Switch
S
WITCH
For information about management of the stack, see "Setting Up for
Management" on page 3-1.
Table 1-2 shows the default settings of the Switch. If you initialize the
Switch, it is returned to these defaults.
Table 1-2
Default settings
Port Status
Port Speed
Duplex Mode
Flow Control
Spanning Tree (STP) Disabled
System Alarm
(broadcast
bandwidth used)
System Alarm
(errors over 1 min)
Enabled
10BASE-T/100BASE-TX ports are auto-negotiated
10BASE-T/100BASE-TX ports are auto-negotiated
Enabled in half duplex (IFM), auto-negotiated in full
duplex
Enabled
High threshold: 20% — Notify and filter
Low threshold: 10% — Notify and unfilter
Enabled
High threshold: 20 errors per second — Notify
Low threshold: 1 error per second — No action