Wall-Mounting - IBM 8271 Nways F12 User Manual

2-4 C 2: I
HAPTER NSTALLING THE

Wall-mounting

S
WITCH
A single Switch can be wall-mounted.
ATTENTION: Disconnect any cables from the Switch before continuing.
Remove self-adhesive pads from the underside of the Switch if they
have been fitted.
1 Place the Switch the right way up on a hard flat surface, with the front
facing towards you.
2 Locate a mounting bracket over the mounting holes on one side of the
Switch, as shown in Figure 2-2.
Fitting a bracket for wall-mounting
Figure 2-2
3 Insert the two screws and tighten with a suitable screwdriver.
4 Repeat steps 2 and 3 for the other side of the Switch.
5 Ensure that the wall you are using is smooth, flat, dry and sturdy.
Attach a piece of plywood, approximately 305mm x 510mm x 12mm
(12in. x 20in. x 0.5in.) securely to the wall if necessary.
6 Mount the Switch as follows:
a Position the base of the Switch against the wall (or plywood)
ensuring that the ventilation holes face sidewards and the front panel
faces upwards . Mark the position of the screw holes in both wall
brackets on the wall. Drill the four holes.