To cancel ReView mode:
NOTE: In the event that the aimed point and the Point Mark do
not coincide. Please refer the chapter of "basic procedures"
on the instruction manual for adjusting camera axis using
Correct Center Mode.
4.4 Adjusting the camera settings
SETTING
Snap and photo conditions are defined in the Setting menu in the
camera settings.
4.5 Output of image data
The image data and the survey information are stored in the
memory. The information stored in memory can be output to a
computer by using following interface:
4.5.1 Remove the SD card from Digital Camera
Confirm the camera power is off, and take the SD card from the
camera slot.
An SD card with the capacity up to 1GB can be used.
Make sure that the camera power is off before taking the card
from the slot.
4.5.2 Connecting Digital Camera to a computer by USB cable
Confirm the digital camera power is off and connect the camera
to a computer by a USB cable.
Make sure that the camera power is off when disconnecting the
USB cable.
14