Known Point Setup; Orientation (Station Point H. Angle Setup) - Pentax Visio R-400VDN Series Quick Reference Manual

7.1 Station Point Setup
To input the point information:
ENT
input Point Name by
repeat to input value
NOTE: Input items are PN (point name), IH (instrument height), PC
(point code), TEMP (temperature), PRESS (atmospheric pres-
sure) and ppm. "TEMP" and "PRESS" can be input only when
"Atmospheric Correction" is set to "ATM INPUT". "ppm" can
be input only when "Atmospheric Correction" is set to "ppm
INPUT".The input item (cursor position) may be selected by
,
F3

7.2 Orientation (Station Point H. Angle Setup)

Only when the orientation of the horizontal angle is required,
proceed according to the following procedure.
Otherwise, just pass this step by
To input a given angle:
INPUT
input value by using
F2
Or to set the angle 0°:
0 SET
x2
F1
Or to calculate by Inverse:
ENT
INVERS
F5
LIST
select End Point
F2
from the List
F1
ESC
to quit
or confirm "ppm"
ENT
F4
0
ENT
MULTIPLE
ORIENTATION
LIST
select Start Point from the List
F2
ENT
TO 123
,
0
F5
DEF
SAVE
F1
ENT
ENT
ENT
9 .
DEF
ENT
ACCEPT
x2
F5
27
ENT
9 .
H. ANGLE
SETUP
x2
MULTIPLE
ORIENTATION
ENT
ACCEPT
F5
MULTIPLE
ORIENTATION