Orientation (Station Point H.angle Setup); Stakeout Point Setup; Stakeout Measurement - Pentax Visio R-400VDN Series Quick Reference Manual

9.2 Orientation (Station Point H.Angle Setup)

To input a given angle:
INPUT
input the value
F2
Or to set the angle 0°:
0 SET
x2
F1
Or to calculate by the Back Sight Point:
BSP LIST
F5 F2
ENT
STAKEOUT
COORD. SETUP

9.3 Stakeout Point Setup

Select the point from the stored data:
select the
LIST
F2 point by

9.4 Stakeout Measurement

Check the designed value. If "COMPARE METHOD" is set to "LARGE
CHARACTER" press
Turn the instrument until "DH. Angle" reads to "0".
Select the Target type:
TARGET
repeat
F2
NOTE: You can check the selected target type just at the left of the
Battery mark in the top line of the screen.
To measure in Tracking mode:
MEAS
x2 (move the target until "DH.dist" reads "0")
F1
To quit measurement
ENT
ENT
STAKEOUT
COORD. SETUP
select the point by
FIND PN
F2
SCROLL
to proceed to the Stakeout screen
F3
until the desired target type is selected
MEAS
(position the target accurately)
F1
x2
STAKEOUT
COORD. SETUP
FIND PN
F2
F4
ENT
ACCEPT
F5
F4
31
ENT
ACCEPT
F5
STAKEOUT
MEASUREMENT