S1 Dip Switch; Overview; Operation Modes - Bosch Rexroth IndraControl VDP 08.3 Manual

46/81 Bosch Rexroth AG
Interfaces
7.2.3

S1 DIP Switch

Overview

Operation Modes

Cable length between control cabi‐
net PC and VDP is 5 m maximum
Cable length between control cabi‐
net PC and VDP max. 30 m (stand‐
ard USB mode)
Designa‐ Connection type
tion at the
housing
XVID CDI interface, screen
XUSBIN USB2.0 connection to the
control cabinet PC. Length 5
m max.
Only high-speed USB2.0 ca‐
bles are to be used (see
chapter 12 "Ordering Infor‐
mation" on page
X2 Connection keypad
X3 Connection keypad
Fig.7-2: Interfaces on the VDP 08.3 and VDP 40.3
Designation at the Switch type
housing
S1/switch 1 DIP switch
S1/switch 2 DIP switch
Fig.7-3: DIP switch on the VDP
If the cable length to the control cabinet PC does not exceed 5 m, the USB
connection to the VDP can be executed in the USB 2.0 mode (High Speed,
max. 480 Mb/s) by using an additional USB 2.0 cable. The S1 switch 2 must
be in the "OFF" position. If the cable is not plugged, the USB connection is
executed in USB-1.1 (max. data rate at Full Speed: 12 Mb/s).
The USB connection is executed in the USB1.1 mode. The S1 switch 2 must
be in the "OFF" position.
NOTICE
No internal strokes are to be integrated into the connected USB device (be‐
cause of the additional runtime) so that the standard USB mode works with a
cable length of up to 30 m!
DOK-SUPPL*-VDP*08.3***-PR02-EN-P
Rexroth IndraControl VDP 08.3/40.3 Operator Terminal
Connector type (in‐
tegrated)
RJ45 female con‐
nector
USB female con‐
nector, 4-pin, type B
71)
Phönix male con‐
nector strip, 6-pin,
MCV 1.5/6- G-3.5
Phönix male con‐
nector strip, 10-pin,
MCV 1.5/10-G-3.5
Function
Without function
OFF: Cable length to the control cabinet PC <
30 m
ON: Cable length to the control cabinet PC >
30 m
Malfunctions in the standard USB mode
caused by strokes!
Mating connector or
cable (from outside)
RJ45 connector
USB connector, 4-
pin, type B
Phönix female con‐
nector strip, 6-pin,
FK-MCP 1.5/6-
ST-3.5
Phönix female con‐
nector strip, 10-pin,
FK-MCP 1.5/10-
ST-3.5