Connection Of The Y-Repeater; Connection Of The Y-Repeater (Block Diagram); Pin Assignment On The Y-Repeater; Connection Of Two Operator Displays Via The Y-Repeater - Bosch Rexroth IndraControl VDP 08.3 Manual

66/81 Bosch Rexroth AG
Y-Repeater
10.6

Connection of the Y-Repeater

10.6.1

Connection of the Y-Repeater (block diagram)

10.6.2

Pin Assignment on the Y-Repeater

10.6.3

Connection of Two Operator Displays via the Y-Repeater

Vin
XSER1 and XVID1
XSER2 and XVID2
Fig.10-14: Light-emitting diodes at the Y-Repeater
Fig.10-15: Connection of the Y-repeater
Fig.10-16: Pin assignment of the Y-repeater
To connect two operator displays to a control cabinet PC, the Y-repeater is
switched between the control cabinet PC and the both operator displays. As
the screen signals are transmitted to both operator displays, data can only be
entered with the active operator display. Which of the two operator displays can
be used as active operator display to operate the control cabinet PC, is to be
DOK-SUPPL*-VDP*08.3***-PR02-EN-P
Rexroth IndraControl VDP 08.3/40.3 Operator Terminal
A voltage supply of 24 V is applied
Touch screen operation is activated on the VDP
08.3/40.3 no. 1.
Operation is activated on the VDP 08.3/40.3 no.2.