DOK-SUPPL*-VDP*08.3***-PR02-EN-P
Rexroth IndraControl VDP 08.3/40.3 Operator Terminal
10.3.2
Switching Times without Devices on the USB Connections
10.3.3
Switching Times with Devices on the USB Connections
10.4
Interfaces on the Y-Repeater
10.4.1
View on the Connector Panel
Switching condition
Switching to an other oper‐
ator terminal
Fig.10-3:
Switching times without devices connected to the USB connections
Switching condition
Switching to an operator
terminal to which only al‐
ready known USB devices
are connected on the same
USB port.
Switching to an operator
terminal to which already a
new USB device has been
connected.
Fig.10-4:
Switching times with devices connected to the USB connections
NOTICE
The devices connected to the XUSBx USB connections can be operated up to
three seconds at the disabled VDP. The key operation and touch operation of
the deselected VDP is immediately disabled.
The connections are located at the front panel of the Y-repeater.
Bosch Rexroth AG
Switching time in standard
USB mode
Up to 5 seconds.
Switching time in standard
USB mode
Up to 5 seconds.
Up to 30 seconds.
(time until the USB device
is correctly installed by
Windows)
Incorrect operation at the VDP possible when
switching the Y-repeater.
61/81
Y-Repeater
Switching time in extended
USB mode
Up to 10 seconds.
Switching time in extended
USB mode
Up to 10 seconds.
Up to 30 seconds.
(time until the USB device is
correctly installed by Win‐
dows)