Toro Z Master Professional 7000 Series Operator's Manual page 77

Figure 111
1. Measure here from blade
to hard surface
2. Measure the right blade at the B location, from a
level surface to the cutting edge of the blade tip
(Figure 111).
3. Record this measurement. This measurement
needs to be 80 to 83 mm (3-1/8 to 3-1/4 inches).
4. Position the left blade side-to-side
5. Measure the left blade at the C location
111), from a level surface to the cutting edge of
the blade tip.
6. Record this measurement. This measurement
needs to be 80 to 83 mm (3-1/8 to 3-1/4 inches).
7. If the measurements at positions B or C are not
correct, loosen the bolt attaching the rear chain
to the rear-support arm
Figure 112
1. Rear chain
2. Rear-support arm
3. Bolt
4. Jam nut
g006888
2. Measure at B and C
(Figure 111).
(Figure
(Figure 112).
g001040
5. Adjustment bolt
6. Front swivel
7. Front-support arm
8. Loosen the jam nut under the rear-support
arm and adjust the adjustment bolt to get a
measurement of 80 to 83 mm (3-1/8 to 3-1/4
inches); refer to
Note:
It is recommended that both sides of the
mower are adjusted the same distance.
9. Tighten the jam nut under the rear-support arm
and tighten the bolt securing the chain to the
rear-support arm.
10. Adjust the opposite side if needed.
75
Figure 112.