Toro Z Master Professional 7000 Series Operator's Manual page 15

Side Discharge Machines Only
Note:
This machine complies with the industry standard stability test in the static lateral and longitudinal tests with the maximum
recommended slope indicated on the decal. Review the instructions for operating the machine on slopes in the Operator's Manual as
well as the conditions in which you would operate the machine to determine whether you can operate the machine in the conditions on
that day and at that site. Changes in the terrain can result in a change in slope operation for the machine.
1. Warning—read the Operator's Manual; all operators should
be trained before operating the machine; wear hearing
protection.
2. Cutting/dismemberment hazard of hand—stay away from
moving parts; keep all guards and shields in place.
3. Thrown object hazard—keep bystanders away.
1. Read the Operator's
Manual.
2. Height of cut
132-0871
4. Tipping hazard—do not use dual ramps when loading onto a
trailer; use 1 ramp wide enough for the machine; use a ramp
with a slope less than 15°; back up the ramp (in reverse) and
drive forward off the ramp.
5. Runover hazard—do not carry passengers; look behind you
when moving in reverse.
6. Tipping hazard—do not use the machine near drop-offs or
on slopes greater than 15°; only operate across slopes less
than 15°.
13
127-0326
3. Remove the key and
read the Operator's
Manual before performing
maintenance.
decal127-0326
decal132-0871