Toro Z Master Professional 7000 Series Operator's Manual page 50

Checking the Engine-Oil Level
Note:
Check the oil when the engine is cold.
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Check the engine-oil level
Figure 58
4. Start the engine, run it at idle for 5 minutes,
shut off the engine, wait for 3 minutes, and then
check the engine-oil level. If needed, add oil up
to the F mark on the dipstick.
ULL
Important:
Be sure to keep the engine-oil
level between the upper and lower limits on
the oil gauge. Engine failure may occur as
a result.
Important:
Add the oil very slowly and
do not block the opening of the filler hole
(Figure 58).
g032601
g032641
48
(Figure 40). If you add oil too fast or block
the hole, the oil could back up and foul the
air intakes, causing engine damage.
Figure 59
1. Note the clearance left in the filler opening.
g000955