Toro Z Master Professional 7000 Series Operator's Manual page 65

1. Ratchet with short
extension or breaker
bar
2. 16.5 cm (6-1/2 inches)
between the spring hooks
12. While holding the belt in tension, tighten the 2
bolts that secure the fixed idler arm.
13. Remove the ratchet or breaker bar from the
square hole in the fixed idler arm.
14. Install the belt covers with the tabs in the slots.
Install the screws and close the latches
87).
1. Belt cover
2. Latch
15. Install the sheet-metal guard; refer to
the Sheet-Metal Guard (page
Figure 86
3. Spring-loaded idler pulley
4. Fixed Idler pulley
Figure 87
3. Bolt
4. Install tab into the slot
Removing
42).
16. Tighten the bolt for the mower-deck curtain; refer
to Releasing the Mower-Deck Curtain (page
17. Check the tension on the drive belts.
g005911
(Figure
g012506
63
42).