Avaya S8500 Replacing page 4

Replacing the S8500 dual network interface
Powering down the media server
After the backup is finished, complete the following steps to power down the media server.
1. From the media server Web interface click Shutdown This Server.
2. Select Delayed.
3. After the media server shuts down unplug the power cord from the back of the server.
4. Unplug the power cord from the RSA.
5. Disconnect the modem from the RS-232 port on the RSA.
6. Disconnect and label the LAN connection (if used) from the Ethernet port on the RSA.
7. Pull the server forward so that the server rails expand and the retaining clips on the rails
click into place.
8. Unplug and label the cable from the Ethernet port labeled LINK A on the dual NIC.
Removing the cover of the media server
!
CAUTION:
Remove all power from the media server before starting this procedure.
CAUTION:
To remove the cover of the media server:
1. Loosen the two captive screws on the back of the media server (see
server cover's captive screws
2. Slide the server cover back from the front panel until the cover's tabs are released from the
top slot of the front panel.
3. Lift the cover straight up and move it away from the server as shown in
the server cover's captive screws
4 Replacing the S8500 dual network interface
on page 5.
on page 5.
Figure 3: Locating the
Figure 3: Locating