Operating Procedures; Initial Startup/Pre-Check - Shindaiwa DG150MM Owners And Operation Manual

Diesel engine generator
Table of Contents

Advertisement

Remove the hold-down clamp from the battery on the right side.
4
Remove the clamp and cable from positive (+) post from the battery on the right
5
side. Remove the right side battery from the seat.
※Reinstall the new battery in the reverse order. (always install the cable to the
positive (+) post of the new battery first.)
8.6.2 Replacing the battery installed on the left side toward the control panel
Remove the clamp and cable from negative (-)
1
post from the battery on the left side. (always
remove negative side first.)
Remove the hold-down clamp from the battery
2
on the left side.
Remove the clamp and cable from positive (+)
3
post from the battery on the left side.
Remove the left side battery from the seat.
4
※Reinstall the new battery in the reverse order
(always install the cable to the positive (+) post
of the new battery first.
9.

Operating Procedures

9-1. Initial Startup/Pre-Check

WARNING : EXHAUST GAS POISONING
 Do not operate the generator in poorly ventilated areas such as an indoors
or tunnels, as the exhaust gas of the engine contains substances that are
harmful to human health.
 Do not direct exhaust fumes at bystanders or buildings.
WARNING : INJURY
 Always be sure to check that the breaker on load side and switches for any
equipment using the generator are at "OFF" before turning the breaker to
"ON". Also be sure to advise personnel on the load side that power will be
turned on before operating the breaker.
 Close all doors and lock them during operation.
CAUTION : FIRE
 Do not carry flammable items (such as fuel, gas and paint) or items that are
highly combustible near the generator as the muffler, exhaust gas and other
parts become extremely hot.
 Position this generator 1 m or more from walls or other hindrances, and on
a level surface.
CAUTION : INJURY
 Do not operate the generator if it has been modified or any parts have been
removed.
 Position the generator on a level stable surface so that it cannot slide or
move in any manner.
 Before starting operation, always be sure to turn off all switches of equipment
being used and breaker to "OFF".
(+) Post
Left side battery
25
Hold-Down
(-) Post
Clamp

Advertisement

Table of Contents
loading

Table of Contents