Table of Contents
Advertisement
(6) Fuel Filter Replacement（Main Filter）
Replace
Remove the fuel filter element by a filter remover.
1
Use the Mitsubishi genuine fuel filter element.
2
Fuel filter element part no. :ME056670(Mitsubishi
part no.)
Apply fuel to the gasket in the fuel filter element.
3
Install the oil filter by hand until the gasket
4
contacts the seal surface.
Tighten the filter by 2/3 turn to clockwise with
5
filter wrench.
Start the engine. Make sure that there is no
6
leaked fuel from the seal point.
< Note >
When attaching the Element, check that there is
no foreign material adhering to the gasket.
(7) Draining Water from the Fuel Tank
Drain Water
Place a suitable pan under the drain plug.
1
Remove the fuel drain plug together with a
2
packing. Turn and open the fuel drain valve and
drain the water.
Close the drain valve after drained. Retighten
3
the fuel drain plug together with a new packing.
Do not reuse the packing.
Packing part no.:V106-000190
Make sure that there is no leaking the fuel
4
from the seal point.
(8) Coolant Replacement
Replace
Radiator Plate
Radiator Cap &
Filler Neck
1
Place a suitable pan under the drain hose.
2
Remove the radiator plate and the radiator cap.
Loosen the drain valve.
3
Retighten the drain valve after drained.
4
Remove the coolant sub-tank and drain coolant from the sub-tank, if necessary.
5
Every 500 hrs.
Every 250 hrs.
Every 2 yrs. or Every 1000 hrs.
(whichever come first)
Drain Valve
Drain Hose
35
Mating Mark
Fuel filter (Main)
Gasket
Mark
Fuel Filter Element
assembly
Fuel Drain Valve
(inside)
OPEN
CLOSE
Fuel Drain Plug
with Packing
Coolant
Sub-Tank
FULL
LOW
Advertisement
Table of Contents
