Table of Contents
Advertisement
(2) Double-Stacking Procedures
WARNING : INJURY
Always be sure to observe the following items when double stacking this generator in
a warehouse or similar location.
Check that the hood of this generator is not dented,
and that bolts are not loose or missing.
Set in a location with a flat hard floor capable of
withstanding the double-stacking weight.
Always be sure to use lifting hooks when lifting this
generator.
Insert wood ties of the same size and that are wider
than this generator between each generator, and set
another generator on top of the ties.
Never stack more than two levels, and do not set a
generator on top that is larger in weight/size than that
on the bottom.
Do not operate the generator when it is double
stacked.
12. Troubleshooting
WARNING : ELECTRIC SHOCK/INJURY
Do not touch output terminals or internal electric parts while the generator is
operating.
Do not open the check door during operation. Keep away from moving parts
such as cooling fan and fan belt.
Always be sure to stop the engine and remove the starter key when
performing inspection or maintenance.
CAUTION : FIRE
Never allow flame to come close to the generator.
CAUTION : BURNS
Do not touch the engine and muffler after stopping the engine as they are still
extremely hot.
Inspect this generator when operation is poor to determine the fault/malfunction.
Request the authorized distributor where the generator was purchased to perform
maintenance if you cannot find any faults/malfunctions during inspection.
Problem
Starter motor
1. Battery output is weak.
does not drive
or speed is
2. Battery is deteriorated.
low.
3. Battery terminal is OFF or loose.
4. Battery terminal is corroded.
5. Starter switch or relay is defective.
6. Starter motor is defective.
Suspected cause
38
Action
1. Check / battery liquid / or
Charge.
2. Change battery
3. Fix / Tighten terminal
4. Clean terminal
5. Ask our distributor to repair
6. Ask our distributor to repair
Advertisement
Table of Contents
