Operating Procedures; Initial Startup/Pre-Check - Shindaiwa DGK60D Owner's Manual

Check the fluid level, and add distilled water when it is near the lower level until it
1
reaches the upper level.
Check the terminals for looseness and tighten if loose.
2
< NOTE >
 It is necessary to recharge the battery when the specific gravity of the battery fluid is 1.23 or less.
Request the authorized distributor where the generator was purchased to recharge the battery.
 Replacing the Battery
Remove the battery negative (-) cable. (Always be sure to remove the negative (-) side
1
first. )
2 Remove battery hold-down clamp.
3 Remove the battery positive (+) cable.
Remove the battery.
4
* Install the battery by performing the above procedures in the reverse order.
(First connect the positive (+) cable of the replaced battery. )
9.

Operating Procedures

9-1. Initial Startup/Pre-Check

WARNING : EXHAUST GAS POISONING
 Do not operate the generator in poorly ventilated areas such as an indoors or
tunnels, as the exhaust gas of the engine contains substances that are
harmful to human health.
 Do not direct exhaust fumes at bystanders or buildings.
WARNING : INJURY
 Always be sure to check that the breakers on load side and switches for any
equipment using the generator are at OFF before turning the breaker to ON.
Also be sure to advise personnel on the load side that power will be turned
on before operating the breaker.
 Close all doors and lock them during operation.
(-) Post
Upper Level
Lower Level
26
() Post
Hold-Down
Clamp