5-3. Fuel Piping Switch (3 Way Valve)
CAUTION : FIRE
Always make sure that the engine is stopped when working on piping.
Always be sure to wipe up any spilled fuel.
After working on the piping, check that there is no fuel leakage.
Change the 3 way valve to switch to supply fuel from the external tank. In that case,
the internal fuel tank is not used.
(1) If using the internal fuel tank
The 3 way valve is turned to the "A" side when the generator is shipped from the
factory.
< Note >
When disconnecting piping from the external tank, turn the lever to the "A" side, and attach
the connecting hose to the external tank fuel inlet/return.
(2) If using an external fuel tank
Connect hoses from the external fuel tank to the external fuel inlet and the external
fuel return. Change the lever of the 3 way valve to the "B" side to supply fuel from the
external tank. (Ref."9-5. Connecting with External Fuel Tank")
Inlet Port
6. Transporting/Installing
6-1. Transport Procedures
WARNING : INJURY
Do not lift up the unit using tie down. Use of such could result in the generator falling.
No persons should be under a lifted generator at all time.
CAUTION : INJURY
Always be sure to use lifting hooks when lifting up the generator, and raise it
slowly at a completely vertical angle.
Personnel performing lifting work must wear protective gear such as helmets,
safety shoes and gloves.
Do not move the generator during operation.
(1) Lifting Procedures
Always be sure to use lifting hooks when lifting up the generator, and raise it slowly at
a completely vertical angle.
Position "A"
Position "B"
Retun Port
15
3 Way Valve
External Fuel Return
External Fuel Inlet
Inlet for External
Fuel Supply