Table of Contents
Advertisement
(3) Fuel Gauge
It shows the volume in the fuel tank.
When filled up, it shows 『F』.
When the needle indicator is approaching to『E』, the fuel tank is empty.
Replenish fuel enough promptly.
Generator Meters and Gauges
(1) Voltmeter
The voltmeter displays the 3-phase output voltage (voltage between
R-T) from the generator.Check that 400V is displayed at 50Hz and 440V
at 60Hz during operation.Check that 200V is displayed at 50Hz and
220V at 60Hz during operation if using at the 3-phase 200V setting.
(2) Ammeter
The
ammeter
generator.Turn the ammeter selector switch to "R" to display the output
current of the 3-phase R phase. Turn the switch to "S" to display the
output current of the 3-phase S phase. "T" displays the output current of
3-phase output terminal T.
(3) Frequency Meter
Frequency Meter will display the frequency of the generator.
Please check it showing 50Hz or 60Hz during operation.
Lamps
(1) Preheat Lamp
Turn the starter switch to the "PREHEAT" position.
The glow lamp converts to "red" after approx. 15 sec. after preheating
completes.
< Note >
Do not leave the starter key at "PREHEAT" over 30 sec. otherwise it
may damage the preheating feature.
(2) Pilot Lamp
The pilot lamp turns on during power generates.
(3) Over Load Pre-caution Lamp , and Output Terminal for Lighting of
Additional Lamp (Aux Lamp Terminal)
This lamp starts to flash if the output exceeds around 80% of the rated
output. Use this generator in a range that does not exceed the rated
output while the lamp is flashing. The lamp turns off when the output
drops below 80% of the rated output.
This generator is equipped with an Aux Lamp Terminal. DC 24 V is
output to the Aux Lamp Terminal at the same time as when the Over
Load Pre-caution Lamp is flashing. Refer to the circuit drawing below if
using the Aux Lamp Terminal for a lamp or similar device with a different
setting.
displays
the
output
12
current
(Phase)
from
the
Advertisement
Table of Contents
