Arrow Storage Products BD88GB Owner's Manual & Assembly Instructions page 28

Step 15
BY28
1
Install the fi rst ridge cap on the
completed roof section using bolts
and nuts. Fasten roof panel over-
laps not used for ridge cap. Cover
the head of bolt with the 2" (5,1 cm)
piece of weather stripping tape. Do
not fasten the ends of the ridge cap
at this time.
2
Install the second ridge cap
overlapping the fi rst ridge cap while
installing the remaining narrow roof
panels. Continue weather stripping
the ridge.
3
Fasten the lower end of the panels
to the side wall angles using screws
and washers. Use bolts and nuts
through wall angle overlaps at the
bottom of the panel.
Cut Weather
Stripping and
 Parts Needed For 
Ridge Caps & Panels
Fold Under
9978
STEP
1
8486
STEP
2
28
 8840 Ridge Cap (1)
 9978 Roof Panel (2)
 8486 Ridge Cap (1)
8840
Strips
9978
STEP
3