Arrow Storage Products BD88GB Owner's Manual & Assembly Instructions page 14

Step 1
BY14
The front fl oor frame is made up of
3 pieces. The side fl oor frames and
the rear fl oor frame are made up of 2
pieces. The holes in these pieces will
align when the pieces are positioned
with correct amount of overlap. The
illustrations below show the proper
overall length for the sides, rear and
front. Proceed as follows:
1
Place the front fl oor frames as
shown. Center the ramp, with drain
holes facing outside, on top of the 2
front fl oor frames. Join the frames by
inserting 8 screws.
2
Overlap the side fl oor frames
and the rear fl oor frames as shown.
The holes in these pieces will align
when the pieces are positioned with
correct amount of overlap. See the
illustrations below for the proper
overall length of the side and rear
fl oor frames. Join the frames by in-
serting 4/5 bolts into each frame set
as shown.
3
Double check the length of each
and set these pieces aside for later
use.
 Parts Needed For 
Floor Frame Assemblies
9989
STEP
1
9379
9989
STEP
2
STEP
3
14
 8941 Ramp (1)
 9379 Front Floor Frame (2)
 9377 Rear Floor Frame (2)
 9989 Side Floor Frame (4)
9379
8941
9379
8941
DRAIN HOLES FACE
OUTSIDE
Side Floor Frame 91 1/8" 231,5 cm
9377
95 7/8"
95 7/8"
9377
Front Floor
Frame Assembly
95 7/8" 243,5 cm
9379
9989
Rear Floor Frame 95 7/8"
243,5 cm
9377
91 1/8" 231,5 cm
91 1/8" 231,5 cm
243,5 cm
Front & Rear
243,5 cm