Roland VersaCamm VS-640 Service Notes page 239

Adjustment is completed if the position error of cut line is
8
within the range below. If not, select [SETTING] menu again
for further adjustment.
Mark on the right: Within +/-0.1mm
Mark on the left: Within +/-0.3mm
(Make an adjustment based on the mark on the right)
key : Moves cut position towards front
key : Moves cut position towards rear
key : Moves cut position towards right
key : Moves cut position towards left
ENTER key : Saves new setting
MENU key : Moves out SETTING menu
Perform the test print again for confi rmation. Adjustment is
9
completed if the position of cut line is satisfactory.
If not, repeat the adjustment again.
CUTTING MENU
PRINT-CUT ADJ.
PRINT-CUT ADJ.
SETTING
F:+0.30 +0.30mm
S:+-0.40-0.40mm
-
Left
+/-0.3mm
Broken line is indicating the cut line
4-41
[ ]
[ ]
[ ]
[ ]
Fine Adjustment
-
F:
+
S:
Center Right (Base)
+/-0.1mm