Roland VersaCamm VS-640 Service Notes page 202

I/S MENU
CIRCULATE INK
SERVICE MENU CUTTING MENU
CUTTING MENU CROPMARK SENSE
CUTTING MENU
FORCE ADJUST
CUTTING MENU
CROP-CUT ADJ.
CARTRIDGE SL1 : SERIAL
SLOT 1 1402A30C010000A5
SL1 : INK TYPE
SL1 : CAPACITY
SL1 : LOT NO.
SL1 : CONSUM.
SL1 : TIME
0y000d00h00m00s
SL1 : INSERT
SL1 : FLAG
It reads the information written on the IC of each carriage.
CARTRIDGE
Following messages are displayed when some error is found.
SLOT 2
Ink cartridge is not inserted
CARTRIDGE A cartridge with no IC is inserted, wire break or short
SLOT 8
System error due to the trouble such as a damage of driver IC placed on Ink Tank Board
Data error
CIRCULATE INK CIRCULATING INK
CIRCULATION
CIRCULATE INK CIRCULATING INK
CIR-DISCHARGE
CROPMARK SENSE MIN 0.7V MAX2.3
OUTLEVEL CHECK
CROPMARK SENSE ADJUST
ADJUST
30gf
FORCE ADJUST
30gf
FORCE ADJUST 200gf
200gf
CROP-CUT ADJ.
PERFORMING
TEST PRINT
CROP-CUT ADJ.
F:+0.30 +0.30mm
SETTING S:-0.40 -0.40mm
Returns to menu with [MENU] key
CROP-CUT ADJ. PERFORMING
TEST PRINT 2
4-4
Serial No. of the Ink Cartridge IC is displayed.
Ink type of the Ink Cartridge IC is displayed.
Max K
Ink capacity of the Ink Cartridge IC is displayed.
200cc
Lot No. of the Ink Cartridge IC is displayed.
40216A
Ink consumption of the Ink Cartridge is displayed.
100.000cc
The used time of the Ink Cartridge is displayed.
The insert count of the Ink Cartridge is displayed.
1 times
The Flag information of the Ink Cartridge is displayed.
000000000
SLOT1
NO CARTRIDGE
SLOT1
NO IC CHIP
SLOT1
SYSTEM ERROR
SLOT1
DATA ERROR
This menu is to circulate the white ink.
CIRCULATION : Circulate ink.
CIR-DISCHARGE : Circulate ink and
discharge the determinate quantity of ink.
This is for adjusting the level of Crop Mark Sensor.
[2.0V ] Refer to [4-7 CROP MARK SENSOR ADJUSTMENT].
This is for adjusting the Crop Mark Sensor sensitivity.
There are 3 levels of sensitivity, 0, +1 and +2.
+2 +1
This adjustment may help when Crop Mark detection is
failed with the default level setting.
Default: 0
This is for adjusting the Tool Pressure.
Refer to [4-12 TOOL PRESSURE ADJUSTMENT].
17 16
30gf Range: 0 to 30 Default: 17
200gf Range: 31 to 80 Default: 56
56 57
This test pattern is for adjusting the cut position during
automatic Crop Mark detection. It prints a square
TEST PRINT
Crop Mark and cuts the contour after detecting the mark.
When it shows [
been setup and it needs to be set. In this case, even
if adjustment is unnessesary due to the test result,
[0] must be set here.
This test pattern is for adjusting the cut position during
automatic Crop Mark detection. It prints a square
Crop Mark and continuously prints 0.1mm scales for
TEST PRINT
both scan and feed direction, and then cuts crosswise
after detecting the mark.
], it means that it has never
*****