Roland VersaCamm VS-640 Service Notes page 238

From the test pattern, find the value where the print line
4
matches the cut line.
In this case, the correction value for the scan direction is
"- 0.3".
If it is diffi cult to see the cut line visually, use a mag-
nifi er.
Select [CUTTING MENU]>[PRINT-CUT ADJ.]>[SETTING],
5
and enter the correction-values found in the test pattern for
both Feed and Scan.
F: Feed direction S: Scan direction
Left: Current value Right: New value
(Setting range: +/-5.00mm In 0.01mm unit)
key : Value of F, towards +
key : Value of F, towards -
key : Value of S, towards +
key : Value of S, towards -
ENTER key : Saves new setting
MENU key : Moves out SETTING menu
Select [PRINT-CUT ADJ.]>[TEST PRINT], and press [ENTER]
6
key.
The test print and cut will be performed.
Three marks are printed at the left-end, right-end and the
7
center of the media, and each mark is cut. Confi rm the cut
line positions on the marks visually.
If it is diffi cult to see the cut line visually, use a mag-
nifi er.
<TEST PATTERN>
Correction-value scale
.0 . .0
- .0 - . - .0
CUTTING MENU
PRINT-CUT ADJ.
PRINT-CUT ADJ.
SETTING
F:+0.30
S:+-0.40
CUTTING MENU
PRINT-CUT ADJ.
PRINT-CUT ADJ.
TEST PRINT
Broken line is indicating the cut line
4-40
.0 - .0
. - .
.0 - .0
-0.
0. -0.
0.0 -0.0
Scan
0. 0.0
Feed
-0. -0.0
Cut line
[ ]
[ ]
[ ]
+0.30mm
-0.40mm
[ ]
[ ]
[ ]