Roland VersaCamm VS-640 Service Notes page 201

SERVICE MENU I/S MENU
I/S MENU I/S CHECK
I/S MENU
PUMP CHECK
I/S MENU
I/S CONTROL
I/S MENU
CARTRIDGE
MOVE CARRIAGE NOW PROCESSING..
TO AVOID WIPER
This is for checking the operation of the wiper motor and sensor.
Make sure not to have the Head Carriage and Tool Carriage above the wiper unit during the check.
PUMP SUCTION
PUMP CHECK
PUMP SUCTION A
PUMP SUCTION
CIR-PUMP
PUMP RELEASE
PUMP CHECK
A
PUMP RELEASE
PUMP RELEASE
CIR-PUMP
This is for checking the pump motor. The rotation for both ink suction and release can be checked.
Pump motor rotates for 5 seconds and stop.
I/S CONTROL MOVE CARRIAGE
WIPER/FELT TO AVOID WIPER
The wiper can be moved manually.
Option: ORIGIN / WIPER / FELT / FELT WAITING
Default: ORIGIN
Caution: Make sure not to have the Head Carriage and Tool carriage above the wiper unit during this operation.
Remove all cartridges
before pressing [ENTER] key Set cartridge to SLOT1
IC CHECK
CARTRIDGE
SLOT1
IC CHECK
Error
IC CHECK
SLOT1
Normal
IC CHECK
SLOT1
From SLOT1 to 8 in order
Set cartridge to SLOT12
IC CHECK
SLOT8
Error
IC CHECK
SLOT8
Normal
IC CHECK
SLOT8
IC CHECK
All cartridges must be removed before entering IC HECK menu.
It detects Ink Cartridge IC, writes and loads information, and checks the communication. First, it confirms
if there is the driver for IC detection. The message below is shown when an error is found on the driver.
IC CHECK
SYSTEM ERROR
Next, IC communication is checked individually by slot.
When a cartridge is inserted, it automatically starts to communicate with the cartridge IC for checking. Display
shows [OK], when the communication is done properly. As cartridge is removed, the slot number of next
cartridge to be inserted is displayed. Starting from SLOT1, it continues to SLOT8 in order. When the check
of SLOT8 is completed, the following message is displayed at the end of check.
IC CHECK
COMPLETED
It returns to IC CHECK menu by pressing [ENTER] key. When communication is failed, it displays as below.
IC CHECK
SLOT1 ERROR
It returns to IC CHECK menu by pressing [ENTER] key.
NOTE:
Any cartridge can be used for this check as long as it has IC chip on it.
No information is written on IC chip during this check. (Normally, the count of the cartridge installation is
written. However, the count of the installation in this check is not written.)
Before this IC CHECK, make sure Cartridge Sensor is working properly.
4-3
I/S CHECK
COMPLETED
Checking
Error
I/S CHECK ERROR
WIPER
NOW PROCESSING..
NOW PROCESSING..
NOW PROCESSING..
NOW PROCESSING..
WIPER/FELT
ORIGIN
INSERT
ERROR
OK
INSERT
ERROR
OK
COMPLETED