Roland VersaCamm VS-640 Service Notes page 226

Confi rm that the head is capped properly, and press [ENTER]
4
key. The Tool Carriage will be separated from the Head Car-
riage and the limit position initialize will start.
After initialize is completed, the message is displayed.
To be in the Cut Down condition, move the Tool Carriage
5
with your hand until it makes full contact with the Auto Cutter
Frame.
Press [ENTER] key to perform the Cut Down Position Initial-
6
ize.
After initialize is completed, the message is displayed.
Perform the following adjustment.
[4-6 FLUSHING POSITION ADJUSTMENT]
SETTING UP
DETECTING..
SETTING UP
CUTTER DOWN POS
Auto Cutter Frame
SETTING UP
CUTTER DOWN POS
DETECTING..
INITIALIZATION
4-28
THE LIMIT
[ ]
[ ]
COMPLETED