Error Displays; Error Displays During Normal Measurement - Omron ZX Series Operation Manual

Error Displays

5-1

Error Displays

5-1-1

Error Displays during Normal Measurement

Display
One or all of the judgement outputs are short-cir-
cuited.
→
(Flashing)
EEPROM destruction or data error
→
→
(Flashing)
measure does not solve the problem.
The Sensor Head is disconnected or there is a
Sensor Head error.
→
→
(Flashing)
measure does not solve the problem.
Incident level insufficient or distance measurement
error (Refer to 5-2-5.)
→
mode when changing the gain setting.
(Flashing)
→
(See note 3.)
above countermeasure does not solve the problem.
Incident level saturation or distance measurement
error (Refer to 5-2-5.)
→
mode when changing the gain setting.
(Flashing)
→
(See note 3.)
above countermeasure does not solve the problem.
Distance error
→
(Flashing)
(See note 3.)
Note 1. Although teaching is impossible, threshold values can be input directly
even for an insufficient incident level, an incident level saturation, or a
distance measurement error.
2. The display priority is in descending order from the top of the above
table when more than one error occurs at the same time.
3. The error is displayed only for a Reflective Sensor Head.
142
Cause and countermeasure
Clear the load short-circuit.
Press the ENT Key for 3 seconds or longer.
Replace the Amplifier Unit if the above counter-
Connect the Sensor Head.
Replace the Sensor Head if the above counter-
Optimize the gain setting or select the AUTO
Change to an appropriate workpiece if the
Optimize the gain setting or select the AUTO
Change to an appropriate workpiece if the
Set the workpiece within the measurable range.
Section 5-1
Recovery
Automatic
recovery
Automatic
recovery or
replacement
Automatic
recovery or
replacement
Automatic
recovery
Automatic
recovery
Automatic
recovery