Table of Contents
Advertisement
Through-beam Sensor Heads: FUN M ode Functions
l Default Settings
The settings are initialized to the default setting made at the factory. The
default settings are listed in the following table.
Mode
FUN
Scaling values
Number of samples to aver-
age
Hysteresis
Hold
Timer
Two-sensor operation (when
two Amplifier Units are con-
nected)
Special selection
Monitor focus function
Differentiation function
Display reverse function
ECO display function
Limited number of display
digits
Settings for non-measure-
ment
Zero reset memory function ON
Gain switch
Auto-scale value
T
H threshold value
L threshold value
RUN
Sub-display function
Reference incident level set-
ting
Zero reset function
Function
Refer to 4-5-8 Initializing Settings.
Initial value
OFF
32 samples
0.5% of full scale (FS)
OFF (disabled)
OFF (disabled)
OFF (disabled)
CLOSE
4 V (20 mA): Maximum sensing dis-
tance
−4 V (4 mA): Minimum sensing dis-
tance
OFF (disabled)
OFF (disabled)
OFF (disabled)
All digits displayed
KEEP
METAL
100-L
100.00
0.00
Threshold values
Not set
OFF (invalid)
Section 3-8
101
Advertisement
Table of Contents
