6.2 Zero stitch length
Proper setting
If the zero stitch length is set, the connecting rod (3) should perform no
motion.
Pic. 21: Zero stitch length
(1) - Sleeve
(2) - Screw
1. Set the stitch length knob on the zero cipher.
2. Tilt the machine ( p. 12).
3. Loosen the screw (2).
4. Shift the sleeve (1) until the position is found where the connecting
5. Tighten the screw (2).
32
rod (3) stops moving.
Feeding and presser foot
(3) - Connecting rod
Service Instructions 52Xi, 52Xi-75 - 00.0 - 11/2021
①
②
③