9.2 Trimming lever
Proper setting
The trimming lever (2) should be located as high as possible, but it should
not rub the plate (1). The eccentric bolt (6) groove should be in horizontal
position.
Pic. 36: Trimming lever
(1) - Plate
(2) - Trimming lever
(3) - Screw
1. Tilt the machine ( p. 12).
2. Loosen the screw (3).
3. Turn the eccentric bolt (4) so that the lever (2) does not rub the plate (1),
4. Tighten the screw (3).
5. Loosen the screw (5).
6. Turn the eccentric bolt (6) so that its groove is almost horizontally posi-
7. Tighten the screw (5).
48
①
②
③
however, it should be positioned as high as possible.
tioned.
Thread trimming
⑥
④
⑤
(4) - Eccentric bolt
(5) - Screw
(6) - Eccentric bolt
Service Instructions 52Xi, 52Xi-75 - 00.0 - 11/2021